CG Keys Not Read or Written to CGDI MB DIY Solution

The last batch of CG keys was not read or written to the CGDI MB. The manufacturer CGDI MB recommends replacing the IR receiver and transmitter.

 

 

Here's the customer's good working experience on solving this issue.

There was neither time nor desire to buy it and wait. Therefore, I tried to install the IR receiver and transmitter from an old faulty original key. Now CGDI MB reads and writes perfectly again !!!

Regular keys labeled CG. Of the five keys, only one key was recorded from the fifth time. After replacing IR light and photo diodes, the keys can be read and written without problems.

http://www.key-programmer.org/2021/01/12/solved-cgdi-keys-not-read-or-written-to-cgdi-mb/

AT-200 Programmer Software Update to V1.8.2

CG AT-200 ecu programmer & ISN code reader released newest software V1.8.2 (2020.12.29).

1.Added MED17/EDC17 Data processing tools(Audi/Seat/Skoda/Volkswagen(VW) 4,5 generation anti-theft) engine data analysis modification

4 generation data：VIN, CS, Status, Anti-theft, MAC, PIN

5 generation data：VIN, CS

2.Added Audi/Seat/Skoda/Volkswagen(VW)/Porsche EGS clone models:

DL382(TC1784), DL501(TC1766), DQ250(TC1766): read and write DFLASH, EXT DFLASH, PFLASH

3. Added ECU(Mini)read and write ISN, VIN: MED17.2, MEV17.2.2, MEVD17.2.2

4. Added ECU(Audi, Citroen, Mg, Seat, Skoda, Volkswagen(VW)) read and write VIN:

MED17.1, MED17.5.5

5. Fix some bugs and optimize software performance

 

 

Free download AT200 V1.8.2

https://mega.nz/file/vT4m0ThQ