CGDI MB can not make keys for w202 w210 w208, with existing Motorola based key can not extract password, with ezs eeprom calculated keys not working?
A1:
Yes CGDI cannot add key when exiting key is Moto key.
You can open the key, read moto, get psw from dump ( picture)
Read EZS info, paste Password, save and calculate key dump, write to BE key.
Another answer to Q1:
This is not a problem. Read the eis over obd. save the data. then read moto key with programmer, for example i use carprog. load the key dump into cgdi mb, there you will see the password. add password to eis dump. I think they get the rest alone.
Q2:
So if the key is nec can we add one without soldering , i mean reading IR or OBD . Also are you aware of the problem all key lost in w204?
A2:
If key is NEC, BGA or BE key, no problem to add on bench or OBD.
Also CAN EZS as 204 easy to do by the same way
Q3:
i mean when all key lost for w204 it always fails after asking to put IR key , so cannot make key when all key lost am i right ???
A3:
You need conenct Yellow clip to Kline ESL pin connector to do.
If wires, check your wires connection
http://www.obdii365.com/producttags/cgdi-prog.html
So if the key is nec can we add one without soldering , i mean reading IR or OBD . Also are you aware of the problem all key lost in w204?
A2:
If key is NEC, BGA or BE key, no problem to add on bench or OBD.
Also CAN EZS as 204 easy to do by the same way
Q3:
i mean when all key lost for w204 it always fails after asking to put IR key , so cannot make key when all key lost am i right ???
A3:
You need conenct Yellow clip to Kline ESL pin connector to do.
If wires, check your wires connection
http://www.obdii365.com/producttags/cgdi-prog.html
