How to use the CG FC200 ecu programmer to read and write EDC17CP44 ECU. It’s from an Audi car. This ECU has some internal damage on the unit but it’s working to be able to read and write.
Here we will read and write this ecu with fc200 on bench mode (when the software subscription expired). See what worked and failed.
Select ECU and check wiring diagram
Run FC200 software
Identification
We see the serial, the hardware of the MCU processor
The program already has the ECU clone option if can be cloned directly.
If we want to clone we need to load the original Pflash file but here we don’t want to clone, just want to read the Dflash.
Read and save Dflash
Now read PFlash
It’s reading the the PFlash and it’s work working quite well for this type of ECU.
Click on the Modify VIN option, it is not working as the software has expired, need to renew your subscription to access the server.
Normally if we don’t have a subscription the FC200 will work. you can read and write normally you cannot perform the online functions because your tool ID is not authorized for the server.
Here we want to write the Dflash.
Upload original Dflash
Write Dflash successfully
If we click ECU clone
Load original pflash
FC200 asks to select correction of checksum signature is updated
It failed to clone ECU because software has expired and cannot get authorization code.
If don’t have software subscription you cannot do ECU clone and also other modifications.
We will go back and hit Data process
Select anti-theft processing of VAG
Load Dflash
Load Pflash
Press Parse data
we will get VIN, CS
We don’t have MAC and PIN
If we go to MEDC17 and theft system
We can load pflash and turn off the MEDC17 IMMO system
Save immo off data
IMMO off with cg fc200 successfully
